Cart is empty
Save 27%
DESCRIPTION of Aerial Bracket Lashing Kit
- Top Quality Aerial Bracket Lashing Kit
- U Bolts (38mm) * 2
- J Bolts (150mm) * 2
- Length of Lashing Cable (Approx 5m) *1
- Chimney Corner Pieces * 3
- CC 7312104990 0.660kg N
USES of Aerial Bracket Lashing Kit
- Used in conjunction with chimney brackets and a pole to mount:
- A single aerial
- UHF and VHF aerials
- A broadband antenna
Tools needed
- A ladder
- Roof ladder
- Ratchet & 15mm long neck socket
- Snips
- Vice grips
- Safety equipment (harness, safety mat etc)
Equipment needed
- Chimney bracket (9 inch or 13 inch) with lashing kit
- Pole (1.8m long, 32mm diameter - steel or aluminium)
Location
- On a chimney
Steps to Install
- Position the roof ladder adjacent to the chimney and secure the ladders and put on all safety equipment
- Ascend the ladder with the tools and equipment
- Open the lashing kit bag and wrap the end of the wire coil 4 times around the loop on the "J"-bolt
- Slot the threaded end of the "J"-bolt into the hole in the chimney cradle
- Wrap the wire coil around the chimney keep as straight as possible
- Wrap the wire coil 4 times around the loop on the other "J"-bolt
- Making sure it is just long enough to slot into the other side of the chimney bracket
- Cut off excess wire coil
- Put angle brackets under the wire coil at the other 3 corners of the chimney
- Use the 15mm socket to tighten the nuts on the "J"-bolts while using the vice grips to clamp the "J"-bolt
- Insert the U-bolts into the bracket and loosely tighten
- THE CHIMNEY BRACKET INSTALLATION IS NOW COMPLETE!
